Make 'no raw' mode for D2B to work with new reading/calibration routines
Requested by C. Ritter on 19/6/2019. Now, D2B reading routines use the full tube (instead of the active section 'expanded' to 128 pixels) together with the calibration file generated for the full tube. This works fine with the raw mode, but in 'no raw' mode most of the tubes are discarded, as the efficiency of the top and bottom pixels is almost always larger or smaller than the cut-off values (by default 2.5 and 1/2.5). This is a problem when then 'no raw' mode is needed to remove manually a particular tube that has gone bad. There are 2 possible solutions:
- Take only into account the efficiency of the valid tube section to determine if a tube is bad or not.
- Skip the automatic removal when a list of tubes to remove is provided by the user.